Physics-DPP-9-Electrostatics_raw

PHYSICS Topic: ELECTROSTATICS Date: 1. Six equal resistances are connected between points P, Q and R as shown in the figure. Then the net resistance will be maximum between: (a) P and Q (b) Q and R (c) P and R (d) Any two points 2. In the adjoining circuit, the battery E1 has an emf of 12 V and zero internal resistance while the battery E has an emf of 2 V. If the galvanometer G reads zero, then the value of the resistance X in ohm is : (a) 10 (b) 100 (c) 500 (d) 200 3. In the following circuit, 5Ω resistor develops 45 J/s due to current flowing through it. The power developed per second across 12Ω resistor is : (a) 16 W (b) 192 W (c) 36 W (d) 64 W 4. The total current supplied to the circuit by the battery is : (a) 1 (b) 2 A (c) 4 A (d) 6 A 5. For the circuit shown in the figure, the equivalent resistance between A and B is : (a) 10Ω (b) 8Ω (c) 6Ω (d) 4Ω PHYSICS Topic: ELECTROSTATICS Date: 6. In the given network of resistances, the effective resistance between A and B is : (a) 5 R 3 (b) 8 R 3 (c) 5 R (d) 8 R 7. Five identical resistors, each of value 1100  are connected to a 220 V battery as shown. The reading of the ideal ammeter A is : (a) 1/ 5 A (b) 2/ 5 A (c) 3 / 5 A (d) 4 / 5 A 8. In the network shown, the equivalent resistance between A and B is : (a) 4  (b) 3   3 4 (c) 24  (d) 17   17 24 9. In the given circuit, the resistances are given in ohm. The current through the 10  resistance is 3 A while that through the resistance X is 1 A. No current passes through the galvanometer. The values of the unknown resistances X and Y are respectively (in ohm): (a) 14 and 54 (b) 12 and 6 (c) 6 and 12 (d) 6 and 6 10. A battery of internal resistance 4  is connected to the network of resistances as shown. In order to give the maximum power to the network, the value of R in  should be : (a) 4 / 9 (b) 8 / 9 (c) 2 (d) 18 PHYSICS Topic: ELECTROSTATICS Date: 1. (a) 2. (b) Answer Key 3. (b) 4. (c) 5. (d) 6. (a) 7. (c) 8. (a) 9. (d) 10. (c)

Comments

Post a Comment

Popular posts from this blog

Planning to start your own coaching institute for JEE, NEET, CBSE or Foundation? Here's why not to waste time in developing study material from scratch. Instead use the readymade study material to stay focused on quality of teaching as quality of teaching is the primary job in coaching profession while study material is secondary one. Quality of teaching determines results of your coaching that decides success & future of your coaching while good quality study material is merely a necessary teaching aid that supplements your teaching (video in Hindi)

Image
Read more

Physics-30.24-Physics-Solids and Semiconductors

UNIT 24 - SOLIDS AND SEMICONDUCTORS 1. SOLID STATE ELECTRONICS (SEMICONDUCTORS) (A) Energy bands in solids: (i) In solids, the group of closely lying energy levels is known as energy band. (ii) In solids the energy bands are analogous to energy levels in an atom. (iii) In solids the atoms are arranged very close to each other. In these atoms there are discrete energy levels of electrons. For the formation of crystal these atoms come close together, then due to nucleus-nucleus, electron-electron and electron-nucleus interactions the discrete energy levels of atom distort and consequently each energy level spits into a large number of closely lying energy levels. (iv) The number of split energy levels is proportional to the number of atoms interacting with each other. If two atoms interact then each energy level splits into two out of which one will be somewhat above and another will be somewhat below the main energy level. In solids the number of atoms is very large ( 1023). Hence eac...
Read more

Physics-31.Rotational Mechanics

5.1 DEFINITION OF CENTRE OF MASS Centre of mass: Every physical system has associated with it a certain point whose motion characterizes the motion of the whole system. When the system moves under some external forces than this point moves as if the entire mass of the system is concentrated at this point and also the external force is applied at his point of translational motion. This point is called the centre of mass of the system. Centre of mass of system of n point masses or n particles is that point about which moment of mass of the system is zero, it means that if about a particular origin the moment of mass of system of n point masses is zero, then that particular origin is the centre of mass of the system. The concept of centre of mass is a pure mathematical concept. If there are n particles having mass m1, m2 ….m n and are placed in space (x1, y1, z1), (x2, y2, z2) ……….(x n, y n, z n) then centre of mass of system is defined as (X, Y, Z) where = Y = and Z = where...
Read more